A high-speed atomic force microscope (HS-AFM) requires a specialized set of hardware and software and therefore improving video-rate HS-AFMs for general applications is an ongoing process. To improve the imaging rate of ...

In the present study, a systematic investigation on the effect of Fe content on the Hall-Petch coefficient of (CoCrMnNi)100-x Fex (x = 20, 40, 50, and 60) medium- and high-entropy alloys (M/HEAs) was carried out. The ...

Experiments were performed to investigate bubble behaviors and pool boiling Critical Heat Flux (CHF) on a thin flat rectangular copper heater fabricated on Printed Circuit Board (PCB), at various inclinationangles. The ...

Transportation and controlling fluid flow under high pressures in pumps, valves, boilers and heat exchangers is a common exercise in the industries. The main challenge, however that has confronted designers and manufacturers ...

Solid mine waste management is a continuous and systematic assessment of the potential hazards, disposal, and proper utilization of waste produced in a mining company during the mining and mineral processing stages. In ...

Assessment of blast fragment size distribution is critical in mining operations because it is the initial step towards mineral extraction. Different empirical models and techniques are available for predicting and investigating ...

A transformation-induced plasticity phenomenon in Fe65(CoCrMnNi)35 medium-entropy alloy was investigated. According to the X-ray diffraction patterns, the as-cast specimen contains a single-phase face-centered cubic (fcc), ...

A typical line-scan rate for a commercial atomic force microscope (AFM) is about 1 Hz. At such a rate, more than four minutes of scanning time is required to obtain an image of 256 ' 256 pixels. Despite control electronics ...